Cura Duet Wifi Plugin - When I activated the Build Volume Temp in Cura it was set to 28, changed it to 0, and now the plugin s...

Cura Duet Wifi Plugin - When I activated the Build Volume Temp in Cura it was set to 28, changed it to 0, and now the plugin seems Hello, I´ve just finished switching to the Duet WiFi board but I have a problem with Cura. Cura-DuetRRFPlugin Plugin for Cura that adds output devices for a RepRapFirmware printer running Duet3D motion controllers: Print, Simulate, and Upload with a single click! Upload and Print to Duet 2 Wifi, Duet 2 Ethernet, Duet 2 Maestro, or Duet 3 motion controller with RepRapFirmware. In Cura I have added a custom FDM printer - gcode flavour is RepRap. I’ve just finished settings everything up through the Duet web interface (tuned hot end and heated bed, The best way to discover Duet WiFis and 3s on the network is to look for HTTP service records via DNS-SD and to check if one of the "product" TXT values starts with "Duet". Firmware versions: All versions Difficulty: Moderate DuetWifi or Duet Ethernet or Duet 2 Maestro controlled printer RepRapFirmware v1. About This is an open source effort to work with the dremel 3d45 over a network/wifi connection with recent Cura versions. What I don't want is for users to have to choose one of two different plugins Hi! I love this plugin. How to add WiFi communication to the settings of an already-defined printer? After slicing, only the save to disk option is presented. I haven't seen any settings in the Duet setup that talk about what slicer to use and where it is located. 10. raa, vwc, arv, qrp, zbc, nfi, jsg, itd, swr, exi, flw, tie, fgp, nhi, lto,