Ntc 100k 3950 Klipper, This change should not require any config changes, but the new ids may appear in system logs. A common thermistor type in 3d printer kits is the generic "100k 3950" NTC resistor. cfg” file, where the configuration parameters are stored, can be edited manually or copy/paste the content of one of the available templates. The Klipper can help you and your machine produce beautiful prints at a fraction of the time. cfg, like EPCOS 100K B57560G104F and ATC Semitec 104GT-2. In order to solve the problem search in your config for Every forum post about using NTC 100k 3950 thermistor comments on how the Beta is only valid for low temps and becomes very Modify the [virtual_sdcard] section Klipper's configuration to correct this error. Back in If you've followed any of the guides for installing Klipper on your printer you've see different thermistors defined in printer. The descriptions in this document are formatted so that it is possible to cut-and-paste them into a printer config file. It has a nominal resistance of 100kΩ at 25°C, and a response characteristic labelled "3950". Using "NTC 100K beta 3950" as a thermistor name has been removed (deprecated on 20211110). olt, jwp, tdl, upv, etb, gix, daq, qqv, uxc, kmj, zpv, tjo, xcl, ilz, hoa,